Sometimes it may be useful to edit a few raw measurements in order for example to fix peaks in qc profile due to rod change. The software provides a quick and easy way to locate and fix these values without the use of the CPT data editor. The procedure is described below:
1. Enable the direct edit mode by clicking on the 
button on the main toolbar or from the CPT Data menu select the Enable Direct Edit Raw Data command. The icon on the toolbar will remain pressed (highlighted) 
to visually inform that the feature is enabled.
2. By holding the SHIFT key on your keyboard locate the value you wish to fix.
3. Click on the corresponding cell and edit the value. Press Enter on your keyboard to commit the change or just click anywhere outside the cell. The plot will be updated automatically but no calculations are performed during this step.
4. Disable the feature by clicking on the highlighted icon (in order to avoid any accidental changes in raw data) and recalculate your CPT.
Note Direct edit mode allows changes to depth, qc, fs and u2 values only. |
